![]() This manual mainly assumes that the FANUC SERVO MOTOR α i series of servo motor is used. ![]() The following table lists the manuals related to SERVO MOTOR α i/ β i seriesįANUC AC SERVO MOTOR α i series DESCRIPTIONSįANUC AC SERVO MOTOR α i series / FANUC AC SERVO MOTOR β i series /įANUC SYNCHRONOUS BUILT-IN SERVO MOTOR D iS seriesįANUC AC SPINDLE MOTOR α i series DESCRIPTIONSįANUC AC SPINDLE MOTOR α i/β i series, BUILT-IN SPINDLE MOTOR B i seriesįANUC SERVO AMPLIFIER α i series DESCRIPTIONSįANUC AC SERVO MOTOR α i series / FANUC AC SPINDLE MOTOR α i series /įANUC SERVO AMPLIFIER α i series MAINTENANCE MANUALĬNCs that are described in this manual can be connected to following servo motors and spindle motors. Related manuals of SERVO MOTOR α i/ β i series MANUAL GUIDE i (Set-up Guidance Functions) OPERATOR’S MANUAL MANUAL GUIDE i (For Machining Center System) OPERATOR’S MANUAL (Common to Lathe System/Machining Center System) OPERATOR’S MANUAL OPERATOR’S MANUAL (For Machining Center System) OPERATOR’S MANUAL (Common to Lathe System/Machining Center System) This manual is indicated by an asterisk(*). The following table lists the manuals related to Series 30 i-B, Series 31 i-B, Series 32 i-B. Related manuals of Series 30 i- MODEL B Series 31 i- MODEL B Series 32 i- MODEL B For details, refer to the DESCRIPTIONS (B-64482EN). However, this convention is not necessarily observed when item 3 below is applicable.ģ Some functions described in this manual may not be applied to some products. M series: For the machining center systemĢ Unless otherwise noted, the model names 31 i-B, 31 i-B5, and 32 i-B are collectively referred to as 30 i. The models covered by this manual, and their abbreviations are :ġ For an explanatory purpose, the following descriptions may be used according to the types of path control used: Therefore, matters which are not especially described as possible in this manual should be regarded as ”impossible”. However, we cannot describe all the matters which must not be done, or which cannot be done, because there are so many possibilities. In this manual we have tried as much as possible to describe all the various matters. Should you wish to export or re-export these products, please contact FANUC for advice. ![]() Furthermore, the product may also be controlled by re-export regulations of the United States government. Other models in this manual may also be subject to export controls.įurther, re-export to another country may be subject to the license of the government of the country from where the product is re-exported. The export of Series 30 i-B, Series 31 i-B5 from Japan is subject to an export license by the government of Japan. The products in this manual are controlled based on Japan’s “Foreign Exchange and Foreign Trade Law”.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
January 2023
Categories |